Anything amplifier related, incl DSP and networking boards...
#2924 by pvozelj
May 5th, 2018, 11:14 pm
After the Armonia update I got a yellow triangle warning sign on all 5 output limiters on all channels of our amps saying something like "your setting is too high for your amplifier". Even entering extremely low values like 10V RMS limiter, didnt remove the warning signs. I didnt notice any performance issues with the amps, so I guess its just the software bug.

PS: I would write this post into X4 section of the forum but i get "You are not authorized to read this forum." message everytime I try to open it, even though I registered with serial numbers of our amps.
#2925 by filippo
May 6th, 2018, 1:23 am
Hi pvozelj,

thanks for your feedback. In Armonia 2.11.1 we added the limiter threshold warning but due to a bug the threshold is not correctly handled for X models without Dante board.
Even if this bug doesn't affect the amplifier functionality it will be fixed soon.

Thanks for reporting it.

Best regards.

Filippo