Anything related to 3rd-party or Powersoft extensions...
#2114 by jagrifen
June 7th, 2016, 6:09 pm
I am trying to add some meters for an Ottocanali amplifier within my Qsys design file. It appears the amplifier script has three different RMS outputs for each channel: NI_RMS, PT_NI_RMS, and PT_RMS. Is there any documentation that explains the difference between these three outputs or could someone please describe the differences?
Thanks!
#2649 by luigichelli
June 5th, 2017, 9:35 am
Dear Jagrifen,
at the moment there is no output or input meter information.
The only available infos are related to pilot tone detection and impedance readings as follows:

PT_RMS: is the detected input pilot tone level in tenths of volts (as seen in Armonìa-Source Selection)
PT_NI_RMS: is the measured impedance at a specific frequency (set via Armonìa-Ways-Disagnostic) of the connected load, in tenths of Ohm
NI_RMS: is the measured broadband nominal impedance of the connected load, in tenths of Ohm (as seen in Armonìa-Ways-Disagnostic)