Anything software installation or PC setup...
#2050 by stumpy190
April 1st, 2016, 5:30 pm
Having tried to connect some newly arrived DCell 504 IS 4ch I have been unable to create any communication between my laptop and the modules.
The set-up I have has been used to programme numerous DCell and Digimod units in the past but now an additional problem has occurred when I now try to start Armonia.
No Armonia screen just a small box headed "Armonia - Access control" asking for username and password.
Does anyone have any ideas?
#2054 by AzzimontiMichele
April 4th, 2016, 10:17 am
Good Morning Stumpy,

I guess you accidentally enable the access control. Try with the following:

User: admin
Pass: admin

When Armonía starts, go to the top-left button (with Armonia logo), select "option" than go to the tab "access control".
Here there is a flag to enable the access control, un-tick it and click apply!

Regards

Michele
Powersoft staff