Hi, I have purchased the front and rear kaesop retrofit kit for a K8 amp.
I can see on your Technote 0110 EN how to connect the front RJ45 board to the main Kaesop board.But which of the red sockets on the main board do you connect the rear RJ45 boards to,thanks, Martin

If you have both port kaesop (front and rear) the cable length is assumed can be connected only in the "right" position.
Where right mean:
Rear Port connected to the primary socket, where the 2 AES3 streams and the Ethernet signal are routed together.
Front port connected to the secondary socket, where only the ethernet data are routed.

In Figure below the primary and the secondary socket on the kaesop board.


Regards,
Lawrence.

Thank you.