Anything network wiring & communication, AESOP, etc, goes here...
#2005 by putnamj
January 26th, 2016, 11:43 pm
I've recently installed the KAESOP and KDSP boards into my K20 and am having trouble getting the Firmware Updater to discover/display the amp when it's connected. I know the boards are connected and installed correctly but I must be overlooking something in this firmware update process. There are different firmware versions present across the various boards and I'm trying to update them all uniformly. These are displayed in the Hardware Info section as follows....

-KFRNT: 5.3.8-671
-KCTRL: 5.3.8-671
-KDSP: 5.3.11-3041
-KAESOP: 5.3.8D-661

Neither the Firmware Updater nor Armonía will display the amplifier when it's hooked up. I'm extremely grateful for any assistance with this issue!

#2012 by luigichelli
February 3rd, 2016, 11:45 am
Hi Justin,
Please make sure that the amplifier is set in auto ip mode
menu >settings >network settings >addressing mode >automatic

Than check that also your PC is configured to obtain IP address automatically.

Disconnect any router/switch etc... just plug the PC straight to the amplifier with an ethernet cable.

Open just Armonia OR the firmware updater, those software don't coexist.

If you still experience problems we could set up a remote desktop session to troubleshoot the issue.

Let me know,