Anything software installation or PC setup...
#2887 by matejbaric
March 27th, 2018, 12:04 pm
is there a way to put a selection of input on OperatorView?
For example, I have a few sources to select from (radio, pc, etc.) and a few output zones on ottocanali 100V outputs.
So I'd like to choose from those sources on a tablet for certain outputs. Is this possible? How?
#2888 by luigichelli
March 27th, 2018, 12:16 pm
Hi Matej,
we are working on a solution... actually the only option you have is to save a pawx for every configuration and bind it to the scene recall buttons.
#2889 by matejbaric
March 27th, 2018, 1:10 pm
Thanks. Waiting for news on this. The workaround is cumbersome because this way current volume/mute settings reset themselves after loading...
On ISE2018 I think I saw something similar (although it was directly on amp, not Armonia) but can't find it now at home... is it already available or was it just a demo there? It was a simple interface, not full advanced interface as I can see if I connect to X4's wifi AP. Or is it only on the installation amps?
#2890 by luigichelli
March 27th, 2018, 1:24 pm
It's the GUI, running as a webpage only in installation amplifiers.
#2896 by matejbaric
April 4th, 2018, 9:04 am
Thanks. Would source selection (or matrix mixer) be available by low-level IP control? Is the protocol available?
#2897 by luigichelli
April 4th, 2018, 10:53 am
The protocol is available but does not include source selection or matrix settings at the moment.
We have plans to expand it in the near future.
If you need it just let us know.
#2898 by matejbaric
April 4th, 2018, 10:58 am
Thanks. Yes, protocol would be useful nontheless for potential future projects.