Anything network wiring & communication, AESOP, etc, goes here...
#653 by merc313
June 29th, 2012, 3:06 pm
Hi, I have purchased the front and rear kaesop retrofit kit for a K8 amp.
I can see on your Technote 0110 EN how to connect the front RJ45 board to the main Kaesop board.But which of the red sockets on the main board do you connect the rear RJ45 boards to,thanks, Martin
#657 by lawrence
July 3rd, 2012, 5:26 pm
If you have both port kaesop (front and rear) the cable length is assumed can be connected only in the "right" position.
Where right mean:
Rear Port connected to the primary socket, where the 2 AES3 streams and the Ethernet signal are routed together.
Front port connected to the secondary socket, where only the ethernet data are routed.

In Figure below the primary and the secondary socket on the kaesop board.

You do not have the required permissions to view the files attached to this post.